Customer Rating:  
Summary: Only one filter!!!
Comment: I thought the pack would include 5 filters or at least 2. Only one with this price!
Customer Rating:
Summary: You get but one chance to put it on correctly...
Comment: This is an excellent product when applied correctly. My complaint is that you only get one filter. For $6.00 you'd think there would be at least two in the package...it can't cost more than a few pennies to manufacture one of these. I did get mine applied correctly the first try...well almost.
I used the soapy water solution that one of the other reviewers suggested. This helped a lot and made it easy to position it correctly on the screen. Once all the liquid was pushed out from under the protector film, I could barely tell the film was there. It fit the screen of my brand new PSP slim very well. The problem is that there was a small bubble on the edge that really bothered me (I'm a perfectionist). When I lifted up the edge of the film to remove the speck of dust causing the bubble...it all when to hell!
Once you expose the sticky surface, EVERYTHING sticks to it. Every single speck of dust that sticks to it causes a tiny bubble. As I pulled it up to fix the tiny bubble, it caused two more...as I lifted up to fix those bubbles, it got worse. If only I had a second try of it, I know I could do it...but I don't feel like spending another $6.00 for it.
One other very important note. The volume buttons on my new PSP stopped working about two hours later. I may have gotten some of the moisture inside of the unit. Either that or the unit was already defective...I don't know. Luckily, Amazon sent me a replacement PSP right away (thank you, Amazon!).
Customer Rating:
Summary: Piece of Garbage
Comment: I got this PSP Protective Filter scratched!!!
When I am playing I can clearly see 8 huge scratch on the filter.
On top of that, the PSP Protective Filter does not cover the entire screen!
So, if you feel brave and lucky try it, otherwise you should look for something better.
In conclusion, I will never buy anything else made from this HORI company.
Customer Rating:
Summary: The secret of applying this filter
Comment: Many people have problem applying the filter. If you just peel off and apply the sticker directly, you will face the following 3 major problem:
1. Dust particles
2. air bubbles (or known as air pockets, caused by air or dust)
3. Sticker orientation accuracy
To solve the above problems, here is the secret and the correct steps, not limited to this PSP filter, in fact, this secret applied to all stickers application.
Do the following steps, and you will be amazed with the result.
Ingredients:
a. The screen protector filter
b. Bowl
c. hand soap, body shampoo (lotion, etc.. anything alcaline based will do)
d. water
e. plastic paper credit card sized or smaller which act as your lifter. Optional, use the front/back plastic cover for the sticker will do as well.
f. tissue paper
Step
1. Wipe the PSP screen clean
2. Fill the bowl with one or two teaspoon amount of hand soap and dilute it with half bowl of water.
3. scoop out the bubbles in the bowl as many as possible.
4. Remove both front and back side of the filter. (remember the up-side)
5. Soak the filter into the bowl and take it out with your plastic paper. (try not to use finger)
6. Apply the filter gently (while it is still little wet)
7. Adjust the filter to the correct position desired.
8. Push the liquid out with a credit card from middle to outside.
9. Wipe any water that squeezed out from the corner of the sticker as soon as soon you see it.
10. If you see dust particle (a small air pocket with a little dust dot in the middle) inside the sticker, lift it up with a plaster paper, remove the dust, and close it back.
11. repeat step 7 to 10 until it is completely dry and up to your desire.
If application is not as your desired, remove the sticker, soak it back to the same bowl, clean the sticker to make sure no dust particles with the same way you lean your contact lens, and reapply. (No, you don't have to throw your filter!)
Finally you got yourself a perfect application of filter and air bubble-less.
This is the same technique as applying tinted film/stickers on glass windows, car windows and wind screen by the car assessories professionals. The only difference is they spray soap water on the filter instead of using a bowl (coz PSP filter is so small compared with filter for tinted glass application)
Try it, you will be amazed by the result instead of apply directly without soap water.
Customer Rating:
Summary: Very Good
Comment: This product works well if applied right. Follow the instructions; all instructions, for best results. I had no air bubbles, protects really good, easy to clean. Only thing I have a PSP thin and the filter dosent cover the entire screen, there is a little left over on the edges, not very noticeable though. Only thing I dislike, it only comes with one filter.
|
